Vollrath GRANDE In-Chamber Vacuum Pack Machines - Manual (Page 26)

26
VACUUM PACKING MACHINE
CONDITIONNEUSE SOUS VIDE
MAQUINA DE VACÍO
Operating and service manual / Mode d’emploi et d’entretien
Manual de uso y mantenimiento / Ed. 01 - 2011
REV. 00 - Cod.: 1500386
EN
MEDIO - GRANDE
USING THE APPLIANCE
6.2 OPERATION AND PROGRAMMING
1
SWITCHING ON
Turn On the main switch on the control panel; the LED in the switch lights up; the display shows the initials of the options available for three
seconds; this is followed by display of the program number set in the top quadrant and eventual functions activated in the bottom quadrant.
2
PROGRAM SELECTION: Select the program (from 0 to 9) using arrows .
3
PROGRAMMING THE VAC FUNCTION Enter the programming by pressing : the program number starts flashing. Select the : function;
the VAC function LED starts flashing. Set the required value using arrows and confirm by means of .
4
PROGRAMMING THE SEAL FUNCTION Select the function; the relative LED starts flashing. Set the required value using arrows
and confirm by pressing .
5
STARTING THE WORK CYCLE: Lower the lid with both hands pressing slightly on the corners. The appliance will start the work cycle according
to the programmed parameters.
6
WORK CYCLE END: The appliance ends the cycle automatically after the sealing bar cooling, with air re-entering the chamber resulting in ope-
ning of the lid. Remove the packed product and check the bag seal: it must be uniform, clearly marked without melted points.If necessary, adjust
the preset values and proceed with the second cycle.
INTERRUPTING THE WORK CYCLE
The work cycle can be interrupted at any moment by pressing : interruption is immediate with air re-entering the chamber. The work cycle can
also be interrupted by means of the main switch; the cycle is interrupted but air does not re-enter the suction cup: the lid therefore remains closed.
When the machine is switched on again, the cycle is reset, air returns to the chamber and the lid opens.