WIKA CPG2500 - Manual (Page 55)

Mensor/WIKA Operating Instructions Series CPG 2500 55
Digital Pressure Gauge
SERIES CPG 2500
The ‘Q’ Command Data/Output Format
n Description Output Format
0 Pressure reading in the se-
lected units. This is the default
output format. NNNNNNNwhere each N is a number (0
through 9), +,-,decimal point, or a space. If the pres-
sure rate or peak monitor option is being used the
output format is NNNNNNN,NNNNNNN. The
data before the comma is the pressure and the data
after the comma is the pressure rate or peak.
1 Raw A/D readings (for factory
use) nnnnnnn,nnnnnnn where each n is a number
(0 through 9) or a space.
2 Unit ID Unit ID for the CPG 2500
3 Pressure range and measure-
ment units NNNNNNN,NNNNNNN, @@@@@@@ where
each N is a number (0 through 9), decimal point, or a
space and each @ is an alpha-numeric character. The
output string represents the minimum pressure, maxi-
mum pressure and the pressure units.
4 Error status code CPG 2500’s error codes
5 Calibration data not emulated
6 Pressure rate or peak indica-
tion nnnn where each n is a number (0 through 9) valid only
if optional pressure rate or peak is enabled. The mean-
ing of each digit is shown under the related feature in
the Options section of the DPG II manual.
7 Zero and span corrections ZZZZZZZ,SSSSSSS where ZZZZZZZ is the
zero correction and SSSSSSS is the span correction.
8 Calibration coefficients not emulated
S Command: same as SPAN command.
T Command: used with RATE option; similar to DISPLAY command.