WIKA CPG2500 - Manual (Page 43)

Mensor/WIKA Operating Instructions Series CPG 2500 43
Digital Pressure Gauge
SERIES CPG 2500
RWINDOW? n.nnnnne+nn Returns rate exponential filter window.
SBAUD 9600, 19200, 38400, 57600 Sets the serial baud rate.
SBAUD? XXXX Returns the serial baud data.
SCREENSRC A, B, or A,B, or B,A, or
Delta,A, or Delta,B Sets the CPG 2500 display mode.
SCREENSRC? {A,B or A,Delta or
Delta,B} Returns screen source as one of the
above options.
SDATA 7 or 8 Sets the serial data bits.
SDATA? X Returns the serial data bits number.
SENSORID? Mensor QRS,SN
XXXXXX,VER V.VV Returns the active sensor’s serial number
and firmware version.
SPAN desired pressure or ? Sets span on active channel or for ?,
clears previous value, must be >50% FS
and has a 1% limit.
SPAN? XXXXXXX Returns span scale factor for active chan-
nel.
SPARITY even, odd, none Sets the serial parity.
SPARITY? CCCC Returns the serial parity.
SSTOP 1 or 2 Sets the serial stop bits.
SSTOP? X Returns the serial stop bits.
UNITS units code or text in Table
7.1.3.6. Sets the engineering units for the active
channel.
UNITS? CCCC Returns the pressure units of the active
channel in a text string.
UNLOCK none Releases Acquire locks. See ACQUIRE?
and RELEASE?
WINDOW value in current units Sets the exponential filter window for the
active channel.
WINDOW? n.nnnnne+nn Returns the exponential filter window for
the active channel.
ZERO desired pressure or ? Sets zero to set pressure or for ?, clears
previous value.
ZERO? xxxxxxx Returns zero offset for active channel.