WIKA CPG2500 - Manual (Page 35)

Mensor/WIKA Operating Instructions Series CPG 2500 35
Digital Pressure Gauge
SERIES CPG 2500
7. Remote Operation
Use the following screens to set the operating parameters for Instrument emulation,
Ethernet, Serial (RS-232) and IEEE-488 (GPIB) information.
7.1 Remote Setup
Press the Remote Setup key (computer icon) on the toolbar to configure
remote communication parameters for the CPG 2500.
7.1.1 Instrument Tab
Press the Instrument tab to set the remote communication emulation mode and for
channel selection.
7.1.1.1 Emulation Mode
Mensor: The default command set is Mensor.
2100: The DPG 2100 remote emulation commands and queries information are listed
under the heading ‘Remote Emulation’ in this section.
SCPI WIKA: The SCPI WIKA mode emulates the WIKA command set in SCPI format.
7.1.1.2 Channel
Press this key to select the active remote channel as A or B. This feature is useful for
customers replacing two single channel instruments with a dual channel CPG 2500. The
user selects the channel to be active during remote communications.