SawStop 3.0HP - Manual (Page 46)

44 SawStop 10” Professional Cabinet Saw
Using Your Saw
Replace Cartridge — this code indicates that the brake cartridge has fi red or there is some other permanent
defect that cannot be corrected. If the cartridge has not been fi red, turn off the main power and turn it back on.
If the error continues, install a new cartridge.
Coasting Down — this code indicates that the blade is coasting down and that the safety system is ready to
activate the brake if contact is detected. The safety system monitors the rotation of the blade while it is coasting
down. If you touch the blade while this code is fl ashing, the brake will activate.
Bypass Mode ON — this code indicates that the saw is running in Bypass Mode and will not activate the
brake in the event of accidental contact with the blade. Bypass Mode allows you to cut electrically conductive
materials such as aluminum without activating the brake. When the saw is in Bypass Mode, the safety system
disables the brake. See page 56 for instructions on how to use the saw in Bypass Mode.
Push the Start/Stop Paddle to OFF — this code indicates that the Start/Stop paddle was in the ON position
(i.e., pulled out) before the main power switch was turned on. Push the paddle in to the OFF position to clear
this error. This is a safety feature to prevent the saw from restarting after a power loss or after the safety system
has turned the saw off due to an error detected during use.
Turn Cartridge Key to ON — this code indicates that the cartridge locking key is not turned to ON. To clear this
error fi rst turn the main power switch to OFF, and then make sure the cartridge locking key is correctly installed
and turned to ON.
See page 61 for instructions on how to install and turn on the cartridge key.
No Blade Rotation — this code indicates that the motor is not able to spin the blade as expected. In most
cases this is because the thermal overload switch has cut power to the motor to prevent overheating. If the
thermal overload switch cut power to the motor, wait a minute or two for the motor to cool down to a safe
operating temperature and then push the red thermal overload reset button on the contactor box behind the
left side of the switch box. An audible click will indicate that the thermal overload switch has been reset and the
saw is ready to use. This error code may also indicate that the motor belt is broken and must be replaced.
Adjust Position of Brake Cartridge — this code indicates that the blade is either too far from or too close to
the brake cartridge.
To clear this error fi rst turn the main power switch to OFF, and then adjust the position of
the brake cartridge as described on page 30 . This error code will also be displayed if there is no blade installed,
if a blade smaller than 10 inches is installed, or if a non-conductive blade (e.g. abrasive blade) is installed.
Contact Detected During Standby — this code indicates that the safety system detected contact with the
blade (or a portion of the arbor) when the blade was not spinning. This code will be displayed if you come into
contact with the blade or arbor while the system is in Standby mode. The brake will not be activated and the
code will automatically clear within 5 seconds after contact is ended. The system will not allow the motor to
start while this code is displayed.
ALWAYS MAKE SURE THE BLADE HAS COME TO A COMPLETE STOP AND THE COAST
DOWN STATUS CODE HAS CLEARED BEFORE TOUCHING THE BLADE!