SawStop Front Dust Shroud Replacement - Manual

ICS Front Dust Shroud
Replacement Guide
1.
Remove the table insert and the blade guard. Open the dust shroud door inside the saw and remove
the blade. Leave the dust shroud door open.
Continue on the back side
Tools:
5 mm hex key
Phillips screwdriver
2.
Turn the elevation handwheel to lower the arbor all
the way down.
3.
Using a 5 mm hex key, remove the two socket head
cap bolts that mount the plastic front dust shroud to
the cast iron trunnion brace. Remove the front dust
shroud from the saw.
4.
Turn the elevation handwheel to fully raise the arbor.
5.
Holding the left dust shroud half A (the larger half)
with the screw bosses at the top of the shroud facing
the front of the saw, insert the left dust shroud half
into the saw behind the arbor with the bottom portion
pointed towards the dust port outlet at the bottom of
the cast iron trunnion brace.
Now maneuver the upper portion of the left dust
shroud half around and to the front of the arbor and
move it to the left side of the cast iron trunnion brace,
but do not fully seat it in the saw. Rather, raise the
upper portion so that the screw bosses are above the
table surface to more easily install the blast shield.
right dust shroud half
left dust shroud half
blast shield
button head
Phillip screws
A
C
D
B
dust shroud
assembly
front dust shroud
socket head
cap bolts
A
A
NOTE: Do not assemble the
dust shroud outside of the saw.
SawStop