SawStop 3.0HP - Manual (Page 10)

8 SawStop 10” Professional Cabinet Saw
Thank you for
purchasing this
SawStop ® table saw.
This saw is equipped with the
SawStop ® safety system, designed to
reduce the potential for a serious injury
in the event of accidental contact with the
saw blade.
This saw operates differently than
ordinary table saws. Each operator
must read and understand the
Owner’s Manual before
operating this saw.
To avoid loss of SawStop
protection during coast down,
do not turn off Main Power until
blade has stopped spinning.
WARNING
! ! WARNING
1. Use the blade guard and spreader for every
operation for which it can be used.
2. Use the riving knife for non-through sawing.
3. Keep hands away from the saw blade. Use a
push-stick when required.
! WARNING
Moving belts and parts
can pinch, cut or crush.
Do not operate with
door open.
! WARNING
Moving gears and parts
can pinch, cut or crush.
Do not operate with
door open.
!
WARNING
For your own safety,
read the instruction manual
before operating this saw.
1. Wear eye protection.
2. Use the blade guard and spreader
for every operation for which it can
be used, including all through
sawing.
3. Keep hands out of the line of the
saw blade.
4. Use a push-stick when required.
5. Know how to reduce the risk
of kickback.
6. Do not perform any operation
freehand.
7. Never reach around or over the
saw blade.
8. Never try to test fire the brake
system.
9. Never adjust the position of the
brake cartridge while the blade is
spinning.
10. Do not try to disable the brake
system.
11. Unplug the saw before changing
the blade, changing the brake
cartridge or servicing.
12. Do not connect the motor directly
to a power supply.
13. Use the bypass switch only when
necessary.
14. Do not expose to rain or use in
damp locations.
15. Do not put your hands inside or
underneath the cabinet while the
blade is spinning.
16. Do not unplug or disconnect the
saw from electrical power before
the blade has stopped spinning.
Warning Labels
!
WARNING
Do not operate with door open.
The blade can retract and cause
a severe injury if you touch it inside
the cabinet. Also, moving parts can
cut, pinch or crush.
Warning labels are mounted on the right and back sides of the saw, on
the table insert, on the switch box, on the motor cover, and on the blade guard.
Some of the warnings on those labels may be additional to the warnings listed
above. Be sure to read the warning labels before using the saw. Copies of the
English text of the warning labels are reproduced below: