SawStop 3.0HP - Manual (Page 23)

SawStop 10” Professional Cabinet Saw 21
Assembling Y
our
Saw
Mounting the Extension Wings
6. The hardware required to mount the cast iron extension wings to the cast iron table top is located in the area
with the purple background on the Table Saw Hardware Pack. Position one of the extension wings next to
the left side of the cast iron table with the chamfer toward the front and align the holes in the side of the wing
with the four threaded holes on the side of the table (see Fig. 26). Mount the left extension wing with four M8
washers, four M8 lock washers and four M8 x 20 hex bolts, but do not tighten. Repeat the same procedure to
mount the other extension wing to the right side of the table.
Use a straight-edge to level the extension
wings with the cast iron table top and
tighten all of the M8 x 20 hex bolts with
a 13 mm wrench (see Fig. 27).
Assembling Your Saw
Fig. 26
Fig. 27
8
7
6
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws,
M6 x 20 (2)
9
Switch Box
Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1 Keys,
5 x 5 x 25 (2)
Set Screws,
M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade
Wrench
Holder
13
Button Head
Screws, M6 x 12 (2)
15 Lock
Washers, M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers,
M8 (8) 6 Hex Bolts, M8 x 16 (8) 8 Lock Washers, M8 (8) 7
Tools
Lock Washers,
M6 (2) 10
Washers, M6 (2) 11
Hex Key, M8 (1)
Blade Spacing
Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers,
M5 (3) 4
Button Head Screws,
M5 x 3 x 15 (3) 3