SawStop 3.0HP - Manual (Page 21)

SawStop 10” Professional Cabinet Saw 19
Assembling Y
our
Saw
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws,
M6 x 20 (2)
9
Switch Box
Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1 Keys, 5 x 5 x 25 (2) Set Screws, M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade
Wrench
Holder
13
Button Head
Screws,
M6 x 12 (2)
15 Lock
Washers,
M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers, M8 (8) 6 Hex Bolts, M8 x 16 (8) 8 Lock Washers, M8 (8) 7
Tools
Lock Washers, M6 (2) 10
Washers, M6 (2) 11
Hex Key, M8 (1)
Blade Spacing Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers, M5 (3) 4
Button Head Screws, M5 x 3 x 15 (3) 3
dust
port
Fig. 20
Fig. 21
Fig. 19
fl ange
dust
port
semicircle
Installing the Dust Port
4. The dust port comes attached to the end of a fl exible hose residing within the cabinet. Notice that there is a
small semicircle on the dust port fl ange (see Fig. 19). The dust port must be inserted into the four inch diameter
hole at the back of the cabinet from the inside of the cabinet as shown in Fig. 20. The semicircle acts as a key to
correctly orient the dust port. The hardware required to install the dust port is located in the area with the green
background on the Table Saw Hardware Pack. Remove the three dust port screws and lock washers from the
Table Saw Hardware Pack and place a lock washer on each screw. Keep the screws nearby.
! WARNING
Moving gears and parts
can pinch, cut or crush.
Do not operate with
door open.
3
4
While holding the dust port fi rmly in
place on the inside of the cabinet,
insert each of the three screws into
the holes surrounding the dust port
on the outside of the cabinet, as
shown in Fig. 21. Using a Phillips
screwdriver, tighten each screw
a little bit at a time until all three
screws are securely in place.
Assembling Your Saw
Holding the dust port in your hand, reach inside the cabinet through the opening on the side of the cabinet
through which the motor protrudes and fi t the dust port in the hole so that the semicircle fi ts in the cabinet
and the fl ange around the dust port lies fl at against the inside of the cabinet.
When correctly installed, the
three holes in the cabinet surrounding the dust port will line up with the three