SawStop 3.0HP - Manual (Page 14)

12 SawStop 10” Professional Cabinet Saw
miter gauge
blade guard assembly
riving knife
(installed in saw)
blade wrenches
(two)
owner’s manual table saw hardware pack
handwheel package
(two)
accessory tool holder
OWNER’S MANUAL
10” PROFESSIONAL
CABINET SAW
Model PCS31230
SawStop ®
lock knobs
(two)
push stick
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws, M6 x 20 (2) 9
Switch Box Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1 Keys, 5 x 5 x 25 (2) Set Screws, M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade Wrench Holder
13
Button Head Screws,
M6 x 12 (2)
15 Lock Washers,
M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers, M8 (8) 6 Hex Bolts, M8 x 16 (8) 8 Lock Washers, M8 (8) 7
Tools
Lock Washers, M6 (2) 10 Washers, M6 (2) 11
Hex Key, M8 (1)
Blade Spacing Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers, M5 (3) 4 Button Head Screws, M5 x 3 x 15 (3) 3
Unpacking Your Saw
Remove all packing materials and accessories before removing the saw from the shipping pallet. While
unpacking your saw verify that all the components shown on this page and the following page are included. Use
care when unpacking your saw to prevent damage to any of the saw components or accessories. If the saw or
the accessories have been damaged during shipping, report the damage to your shipper before proceeding with
unpacking. Read and understand this manual fully before assembling and operating your saw.
WARNING! The saw weighs approximately 265 pounds without the extension wings and
335 pounds with the extension wings. Be careful in handling the saw to avoid injury.