Assembling your saw, Assembling y our saw, Installing the elevation handwheel – SawStop 3.0HP User Manual
Page 19: Sawstop 10” professional cabinet saw 17, Fig. 9, Fig. 8, Fig. 10, Fig. 11, Fig. 7, Fig. 12
SawStop 10” Professional Cabinet Saw 17
Assembling Y
our
Saw
handwheel
elevation
control shaft
Fig. 9
1
elevation
control shaft
key
Fig. 8
2
set screw
handwheel
Fig. 10
handwheel
elevation
lock knob
Fig. 11
handle
Fig. 7
handwheel
!
WA
RNI
NG
Do
not oper
ate with door op
en.
The blade can r
etr
ac
t and cause
a se
ve
re injur
y if y
ou touch it insi
de
the cabinet
. A
lso
, mo
ving par
ts can
cut
, pinch or crush.
elevation
control shaft
handwheel
elevation
lock knob
Fig. 12
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws,
M6 x 20 (2)
9
Switch Box
Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1
Keys,
5 x 5 x 25 (2)
Set Screws,
M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade
Wrench
Holder
13
Button Head
Screws,
M6 x 12 (2)
15
Lock
Washers,
M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers,
M8 (8)
6
Hex Bolts, M8 x 16 (8)
8
Lock Washers, M8 (8)
7
Tools
Lock Washers,
M6 (2)
10
Washers, M6 (2)
11
Hex Key, M8 (1)
Blade Spacing
Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers,
M5 (3)
4
Button Head Screws,
M5 x 3 x 15 (3)
3
Installing the Elevation Handwheel
2.
Open one of the handwheel packages included with your saw and screw the handle into the handwheel (see
Fig. 7). Tighten the handle with a 14 mm wrench. The hardware required to install the elevation handwheel is
located in the area with the blue background on the Table Saw Hardware Pack. Remove a key from the Table
Saw Hardware Pack and insert it into the slot at the end of the elevation control shaft (see Fig. 8). Slide the
handwheel onto the end of the elevation control shaft (see Fig. 9) until the face of the handwheel is fl ush with
the end of the shaft. Remove a set screw from the Table Saw Hardware Pack and insert it into the small hole
located on the side of the handwheel (see Fig. 10). Use a 3 mm hex key to fully tighten the set screw. Locate
the lock knob with the longer shaft. Screw the lock knob into the end of the elevation control shaft (see Fig. 11),
but don’t tighten it completely. The lock knob is used to prevent the handwheel from turning after the blade has
been set to a new elevation.
Assembling Your Saw