SawStop 3.0HP - Manual (Page 24)

22 SawStop 10” Professional Cabinet Saw
Mounting the Switch Box
7. The hardware required to mount the switch box is located in the area with the orange background on the Table
Saw Hardware Pack. Remove two M6 x 20 button head socket screws, two M6 lock washers and two M6
washers and place a lock washer followed by a washer on the end of each screw. Mount the switch box under
the left extension wing by inserting the screws into the two holes at the upper end of the switch box mounting
bracket (see Fig. 28) and threading them into the holes towards the front of the left extension wing (see
Fig. 29). Tighten the screws with a 4 mm hex key.
Fig. 29
9
10
11
SawStop System Status Codes
Status Red Grn
¯ ¯ ¯
Wet Wood Overload Due To During Bypas s Contact Detected During Standby Contact Detec ted Brake Adjust Position of Doors Close Access Key To “On” Turn Cartridge To “Off” Turn Start Swi tch Bypass Mode O n
Coasting Down Replace Cartri dge
System Ready System Initia lizing
• • • • • •
¯ ¯ ¯
¯ ¯ ¯
• • • • • •
¯ ¯ ¯ • • • • • •
• • • • • • • • • • • •
• • • • • •
¯ ¯ ¯ • • • • • •
Mounting the Switch Box
Hardware for Step 7
Button Head Socket Screws,
M6 x 20 (2)
9
Switch Box
Keys (2)
Installing the Handwheels
Hardware for Steps 2-3
1 Keys,
5 x 5 x 25 (2)
Set Screws,
M6 x 8 (2)
2
Mounting the Dust Port
Hardware for Step 4
Mounting
the
Motor
Cover
Hardware for Step 5
F
Mounting the
Wrench & Tool
Holders
Hardware for Step 8
Motor
Cover
Rod
5
Blade
Wrench
Holder
13
Button Head
Screws, M6 x 12 (2)
15 Lock
Washers, M6 (2)
14
12
Mounting the Extension Wings
Hardware for Step 6
Washers,
M8 (8) 6 Hex Bolts, M8 x 16 (8) 8 Lock Washers, M8 (8) 7
Tools
Lock Washers,
M6 (2) 10
Washers, M6 (2) 11
Hex Key, M8 (1)
Blade Spacing
Adjustment Gauge (1)
Hex Keys: M3 (1), M4 (1), M5 (1), M6 (1)
Lock Washers,
M5 (3) 4
Button Head Screws,
M5 x 3 x 15 (3) 3
mounting
holes
switch box
mounting
bracket
Fig. 28
Assembling Your Saw