Rugged Ridge PowerTop Kit, 07-14 Jeep Wrangler Unlimited (JK), Black - Manual (Page 42)

Section I Page 40
©2012
5
7
Use tree fasteners to fasten the rear guard.
6
Place the rear guard over the side assembly.
4
Use tree fasteners to fasten the rear guard.
5
With Power Top in the down and open position. Attach
the Velcro® strip to the lower canvas flap. Remove the
adhesive liner from the Velcro® strip. Pull the canvas
flap with attached Velcro® strip to the inside of the rear
guard so that the Velcro® strip adheres to the inside of
the rear guard.
NOTE: Initial closing of the Power Top canvas may
be difficult to close and latch. We recommend upon
completion of installation that you close and latch
the Power Top for at least 24 hours. This time will
allow the Power Top to stretch and settle to the
shape of the vehicle.
Congratulations! Rugged Ridge® Power Top
installation is now complete.
After the Power Top has been closed and latched 24+
hours, we recommend opening, closing and latching the
Power Top several times to ensure proper function. We
also recommend a test drive.
Refer to the Operational Procedure found on page 3 on
opening and closing the Power Top.
See trouble shooting on page 41 if problems occur.
At Rugged Ridge® we are dedicated to your
satisfaction and your feedback is important to us.
Please provide us with any feedback you may have
regarding this or any other Rugged Ridge® product so
we can continue to improve.
Contact Technical support if you need any assistance.
Telephone: 1-800-449-6649
Fax: 770-614-6069
[email protected]