Rugged Ridge Tail Light Euro Guards, 07-14 Jeep Wrangler (JK) - Manual

2007 Jeep® JK Wrangler H/D Taillight Guards Kit
11226.02 (Black)
11103.03 (Stainless Steal)
Components:
(1) Driver’s side rear guard (1) Passenger’s side rear guard
(8) Black plastic taillight lens spacer (4) Small 2” Philips head screw
(4) Large 2” Philips head screw
Installation Instructions:
Note: Early 2007 JK’s were supplied with torx head screws to retain the rear lens. If
your JK Wrangler has these torx head screws you will need a T20 screw driver for
removal. This kit replaces these screws with a standard Phillips head design.
Step1: Select Driver’s or passenger side lens. Instructions will be the same.
Remove original screws (Fig.1). With the screws removed be careful
not to change the position of the taillight assemble. Note the size
difference of the two screws. The large size goes to the outside of the
lens (Fig.2).
Fig.1 Fig.2