Rugged Ridge 4 1/4-inch Oval Tube Side Steps, Black, 07-14 Wrangler Unlimited (JK) - Manual

INSTALLATION INSTRUCTIONS
07- 08 Jeep Wrangler 4-Door Side Bars
3-inch round Black, Textured Black, Stainless
4-inch Oval, Textured Black, Stainless
4-inch Round Stainless
PARTS LIST
(1) Driver Side Bar
(1) Passenger Side Bar (2) Front Brackets (Driver/Pass)
(2) Middle Bracket (Driver/Pass) (2) Rear Bracket (Driver/Pass)
(12) M6X25mm Button Allen Head Cap Bolts (12) M6 lock nuts
(24) M6X22mmX3mm thick Flat Washers (2) M8X35mm Hex Head Bolts
(12) M8X25mm Hex Head Bolts (14) M8 Lock Washers
(2) M8X25mmX3mm Thick Flat Washers (12) M8X15mmX3mm Thick Flat Washers
(6) M10X35mm Hex Head Bolts (6) M10 Nut Plates
(6) M10 Lock Washers (6) M10X30mmX3mm thick Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Locate, remove and set aside the front, middle and rear bar mounts, and the
hardware kit.
Left Side – Driver’s Side Brackets
RR-A or RR-L (Rear Driver’s side – left )
CTR-A or CTR-L (Center Driver’s side - left)
FR-A or FR-L (Front Driver’s side - left)
Right Side – Passenger’s Side Brackets
RR-B or RR-R (Rear Passenger’s side - right)
CRT-B or CRT-R (Center Passenger’s side – right)
FR-B or FR-R (Front Passenger’s side – right)
3. Install the front, middle, and rear nut plate into the frame openings (Fig 1) with the nut
facing up. Note: Later model JK’s may not need the rear nut plate installed. An 8mm
bolt will be used to screw into existing body mounted location..
4. Attach the front, middle and rear bar mount on the driver side with one of the 12MM
bolts, lock washer and washer. (Fig 2). See note above regarding rear mounting
plate. 8MM bolt may be needed. Do not tighten at this time.
Fig 1.
Note how
nut should
be installed
facing up.
Photo
shows nut
facing
down
Fig 2