Rugged Ridge PowerTop Kit, 07-14 Jeep Wrangler Unlimited (JK), Black - Manual (Page 23)

Section E Page 21
Care must be taken while cutting switch openings
because plastic is thick. Cut off lower panel of the
A-pillar switch pod. Be careful to cut along the inner wall
as indicated. This will insure that the cut is not too large
for the switch. Run utility knife over the cut lines
several times before cutting through the plastic.
If needed cutting blade can be heated to aid in cutting
the plastic.
Cutting/Sharp Edge Hazard: Cut carefully
using gloves and eye protection.
22
©2012
CAUTION !
Remove drivers side sun visor and upper and lower
A-pillar trim panels.
18
Route the cable with three plugs along the drivers side
A-pillar.
20
Install trim clips onto your A-pillar switch pod.
2 switch pods are provided. Choose the switch pod that
fits your vehicle.
19
21
CUT ALONG INNER WALL
2007-2010 Jeep® 2011+ Jeep®