Agilent Technologies VXI E1439 - Manual (Page 209)

199
Agilent E1439 Programmer's Reference
Error messages
Error messages
Warnings and errors are based on the value VI_ERROR
Error
Number
Parameter Description
0x0000 AGE1439_SUCCESS No error, command succeeded
0x80000000+0x3FFC0800 AGE1439_ERR_BASE Base number for error values
AGE1439_ERR_BASE +
0x0001
AGE1439_BAD_COMMAND Invalid command code
AGE1439_ERR_BASE +
0x0002
AGE1439_INVALID_HW_CONFIG The hardware configuration is not supported
AGE1439_ERR_BASE +
0x0003
AGE1439_PARM_ERROR Invalid command parameter
AGE1439_ERR_BASE +
0x0004
AGE1439_NV_SAVE_ERROR Error while saving to non-volatile memory
AGE1439_ERR_BASE +
0x0005
AGE1439_DOWNLOAD_ERROR Error while downloading new firmware
AGE1439_ERR_BASE +
0x0006
AGE1439_SERIAL_TIMEOUT Serial bus time-out; hardware error
AGE1439_ERR_BASE +
0x0007
AGE1439_BYTE_SWAP_ERROR Incorrect byte-order setting
AGE1439_ERR_BASE +
0x0008
AGE1439_START_ERROR Start error
AGE1439_ERR_BASE +
0x0009
AGE1439_HARDWARE_FAILURE Hardware failure
AGE1439_ERR_BASE +
0x000a
AGE1439_WATCHDOG_RESET_ERROR Watchdog timer caused a hard reset, possibly
due to a hardware problem
AGE1439_ERR_BASE +
0x0011
AGE1439_NO_DATA_MEASUREMENT_IN_PROGRESS No data available, a measurement is in
progress.
AGE1439_ERR_BASE +
0x00102
AGE1439_NO_DATA_MEASUREMENT_PAUSED No data available, the measurement is paused
AGE1439_ERR_BASE +
0x0013
AGE1439_NO_DATA_WAITING_FOR_TRIGGER No data available, trigger has not occurred
AGE1439_ERR_BASE +
0x0014
AGE1439_NO_DATA_WAITING_ FOR_ARM No data available, acquiring pre-trigger data
AGE1439_ERR_BASE +
0x0016
AGE1439_NO_E1439_FOUND No AGE1439 found at specified logical
address
AGE1439_ERR_BASE +
0x0017
AGE1439_PROC_READY_TIMEOUT Time-out is waiting for AGE1439 command
processor
AGE1439_ERR_BASE +
0x0018
AGE1439_MEMORY_ALLOCATION_ERROR Memory allocation error