HID FARGO HDP8500 User Guide User Manual

Page 179

179

HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1

No Laminator Film
Installed

No laminator Film is
installed in the laminator
unit.

Ensure that the appropriate
Laminator Film is installed.

To cancel the print, press the
Cancel Print button or the Cancel
button located on the Printer.

Wrong Laminator
Film Installed

An incorrect laminator film
has been installed, or a
driver setting is incorrect.

Ensure that the appropriate
Laminator Film is installed and
press the Resume button located
on the Printer to continue printing.

To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.

Laminator Film Out

The Film installed in the
laminator is empty.

The Film installed in the laminator is
empty.

Laminator Film
Break/Jam

A Film break/jam has
been detected inside the
Laminator.

The printer has determined that one
or both overlaminate films have
either jammed or broken.

a. Open the Laminator Cover and

remove the Laminator
Cartridge(s). If overlaminate is
jammed, remove jam and tighten
the material

b. Clear any cards in the printer by

using the Forward and/or Back
buttons located on the Printer's
LCD display.

c. Tape the ends of the

overlaminate together and wind
any excess onto the Take-up
Spool of the Overlaminate.

d. Re-install the Laminator

Cartridge(s), close the Laminator
Cover and press the Resume
button located on the Printer's
LCD display to continue printing.

e. To cancel the print, press the

Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.

Laminator Film

The Laminator cannot find
the next panel on the

Check that the Film is installed