Using the transfer eof (end of form) option, Using the transfer temp offset option – HID FARGO HDP8500 User Guide User Manual

Page 131

131

HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1

Using the Transfer EOF (End of Form) Option

Follow this instruction.

Step

Procedure

Print the Alignment Card Self-test.

Setting the EOF positive (i.e. to a + number) will cause the image length to
SHORTEN

Setting the EOF negative (i.e. to a

– number) will cause the image length to

GROW.

Using the Transfer Temp Offset Option

This option adds an offset to the temp the printer is reading from the transfer roller. (Note: This
setting should be used only to make the temp of the transfer roller and the goal on LCD match.)

Use the slider on “Image Transfer” tab to make adjustment for card stock. (Note: A “-”
Adjustment will increase the actual temp of roller.)

Danger:

The Printer‟s Transfer Roller can reach temperatures exceeding 350 degree F

(175 C). Use extreme caution when operating the Transfer Roller. Never touch the Transfer
Roller unless the Printer Power has been turned off for at least 20 minutes.

Type

Description