Using the lamination card backup option, Using the lamination card length option, Using the lamination fan speed option – HID FARGO HDP8500 User Guide User Manual

Page 138: Using the lamination peel off delay option, Reviewing the no printer connected error message

138

HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1

Using the Lamination Card Backup Option

This option changes distance card backs up after lam pressure is first applied

Using the Lamination Card Length Option

This option dictates length of card (should not be adjusted)

Using the Lamination Fan Speed Option

This option adjust the fan speed level 0 - 100%, 1 - 75%, 2 - 50%, 3 - 25% (replicate printer fan
speed control)

Using the Lamination Peel Off Delay Option

This option adjust the delay between lamination stage and peel off stage.

Reviewing the No Printer Connected error message

If there is no Printer connected or if the Driver is unable to communicate with the Printer, the
following error will be displayed and the grid will be blank.