HID DTC1250e/DTC1000Me/DTC4250e User Guide - Manual (Page 42)

DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
Page 42 April 2014
Setting Description
Write Heat Offset
Adjust the Write temperature for the rewriteable cards as needed.
Increase the
Current Setting to cause more heat to be used in
the printing process of a rewritable card.
OR
Decrease the
Current Setting to cause less heat to be used in
the printing process of a rewritable card.
Note: Write Heat Offset provides user capability to control the
printhead heat level when the Write Operation is performed.
Appropriate heat levels should be applied for the proper writing
process.
Flipper Home Offset
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Flipper Eject Height
Offset
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Mag Super-Co Voltage
Offset
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician..
Mag Medium-Co Voltage
Offset
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician.
Head Home Offset
This setting is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician
Head Print Offset
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Head Contact Offset
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value
may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.