HID DTC1250e/DTC1000Me/DTC4250e User Guide - Manual (Page 41)

DTC1000Me/DTC1250e/DTC4250e Card Printer User Guide, PLT-01668, Rev 1.1
April 2014 Page 41
Setting Description
Sleep Time The Sleep Time setting adjusts the number of minutes of
inactivity before the Printer enters a low power sleep state.
OLED Contrast
(display contrast) Use this option to increase or decrease the contrast of the printer
OLED (if applicable).
Ribbon Calibrate Blue This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Cleaning Rate Use this option to adjust the number of cards printed before the
Printer displays a message indicating cleaning is needed.
The default value is 3000 cards.
Mag HI-Co Voltage Offset This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Mag Lo-Co Voltage Offset This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Ribbon Green LED Level This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Ribbon Blue LED Level This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Erase Heat Offset
Adjust the Erase temperature for the rewriteable cards as
needed.
Increase the
Current Setting to cause more heat to be used in
the erasing process.
OR
Decrease the
Current Setting to cause less heat to be used in
the erasing process.
Note: Erase Heat Offset provides user ability to control the
Printhead heat level when the Erase Operation is performed.
Appropriate heat levels should be applied for the proper erase
process. This setting should be adjusted for proper erasure.