HID DTC1000/4000/4500 Ethernet User Guide User Manual
Page 57
DTC1000/1000M/4000/4500 Ethernet User Guide
– Installation Guide L001411
(Rev.1.1)
57
How do I print
the setting card
if there is no
display
available?
If your model does not have a display, then press and hold the PAUSE
button for 4+ seconds to print a settings card. The printer must be ready
and idle for the card to print.
How do I
choose a static
IP address for
my Ethernet
Printer?
You can use the web pages if you know the current IP address.
OR
You can use IP Tracer which allows you to find Fargo-compatible Printers
and specify their addresses.
(Note: You can save static addresses. However, they are not used until
you reconfigure the Printer to use those static addresses and reboot the
Printer.)
How do I set
the Printer to
work with a
static IP
address?
You can use the web pages if you know the current IP address.
Select the Use the following IP address button on the Network web
page.
OR
Use IP Tracer, which allows you to find compatible Printers and
specify their addresses.
What do the
LEDs by the
Ethernet
connection on
the back of the
Printer
indicate?
The LEDs indicates network activity.
How do I print a
test page from
Windows to
verify the
Ethernet
configuration of
the Printer and
Printer Driver?
Follow this procedure.
1. Open the Printer Driver properties window.
2. Select Start -> Settings -> Printers and Faxes -> [your Printer Driver
name (i.e., DTC1000, DTC1000M, DTC4000, DTC4500 Card Printer)]
-> Properties.
3. Ensure that the printing preferences are set correctly for the Ribbon
installed in your Printer. Then select the Print Test page button.