HID DTC1000/4000/4500 Ethernet User Guide - Manual (Page 16)

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411
(Rev.1.1)
16
Telnet Command Command Purpose Command Format
address.
mask Store a new address
mask. store net mask
gateway Store a new default
gateway.
store net gateway
dns Store a new DNS
server address. store net dns
domain Store a new DNS
domain suffix. store net domain
opts Enable or disable
automatic address
assignment using
DHCP. Static (non-
automatic) addresses
will come from the
stored or default
settings, depending on
the other settings. To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
from Restore the network
settings from either the
default settings or the
current settings. store net from default|current
ifc mode Specify the Ethernet
interface mode as:
automatic, full or half
duplex; 10 or 100 mHz. store ifc mode
auto|10half|10full|100half|100full
from Set the Ethernet mode
settings from the
default or current
settings. store ifc from default|current
save Save all current
settings as the stored
settings in the
permanent memory. save
load Take the settings from
the stored memory and
make them the current
settings. load