HID DTC1000/4000/4500 Ethernet User Guide - Manual (Page 5)

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411
(Rev.1.1)
5
Safety Messages (review carefully)
Symbol Critical Instructions for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the left).

To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.

To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.

To prevent personal injury, make sure only qualified personnel
perform these procedures.
Caution: This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the left).

To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.

To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies. To prevent
equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid
potential damage).

To prevent equipment or media damage, always remove the Ribbon
and Cards from the Printer before making any repairs, unless otherwise
specified.

To prevent equipment or media damage, take jewelry off of fingers
and hands, as well as thoroughly clean hands to remove oil and debris
before working on the Printer.