HID DTC1000/4000/4500 Ethernet User Guide - Manual (Page 15)

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411
(Rev.1.1)
15
Telnet Command Command Purpose Command Format
faults.
dest Change the destination
of a system log path.
This may be set to
none, e-mail, udp or
tcp. set logpath dest
none|email|udp|tcp
email Change the e-mail
address for e-mail
notification for a
system log path. It
must specify a valid e-
mail address. set logpath email
udp Specify the IP address
of the UDP system
logging program. set logpath udp
from Restore system log
path settings from the
default or current
settings. set syslog from default|stored
set user add Add a new User
definition.
Up to four (4) Users
may be defined.
set user add
del Delete a User
definition. set user del
passwd Define a new password
for a User. set user passwd
[]
type Specify a User as root
or guest.
Only root Users have
administrative rights to
change network
interface settings.
set user type
root|guest
from Restore User setting
from default or stored
settings. set user from default|stored
store net addr Store a new IP store net addr