HID DTC1000/4000/4500 Ethernet User Guide - Manual (Page 54)

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411
(Rev.1.1)
54
Question Answer
Can I print from
my PC to an
Ethernet Printer
on a different
network
segment? Yes. If you know the IP address of the Printer on any segment of your
network, you will be able to print to it.
Can I use IP
Tracer to locate
Printers on a
different
network
segment? No. The IP Tracer can only locate Printers located in the same network
segment (as the PC running IP Tracer).
How do I
upgrade the
Printer
Firmware in my
Ethernet-
enabled
Printer? This is done in the same manner as a USB connected Printer, or from the
Upgrade web page of the Print Server. The PC doing the upgrade must
have a Driver installed for the Printer to be upgraded.
Follow this procedure.
1. Run the Diagnostic Utility from the start menu: Go to the Start ->
Programs ->Fargo -> Fargo Workbench Printer Utility->Fargo
Workbench.
2. Select the Printer to upgrade from the drop-down box.
3. Select Upgrade Firmware from the Application icon.
4. If you need to download the update file from the Internet, select the
Technical Support Website link.
5. Choose the update file with the Browse button.
6. Select the OK button.
What is the
default User
name and
password for
the Printer? The default passwords are blank (i.e., an empty string).

The default Users are as follows: root as the administrative User and
guest as a non-administrative User.

The Printer supports four (4) Users.
What if I lose
the password
for my Printer or
it is not
accepted? Procedure for units with a display:
1.) Press the button for information on the display.
2.) Press the down arrow button until “Network” is highlighted.
3.) Press the button for Enter.
4.) Press the down arrow button until
“Rst Password” is highlighted.
5.) Press the button for Enter.
6.) Press the button for OK (check mark).