Allied Telesis 9700 iMAP - Manual (Page 46)

Log into the system Check software load
ATI 9700 - Installation Guide (Initial Installation of the ATI 9700) 1-40
Software Options.............. Customer Build
Software Created.............. Thu 07/15/2004 at 11:14a
SDRAM (free/total)............ 180786 KB / 262144 KB
Flash (free/total)............ 100476 KB / 130560 KB
Booted from................... preferred
Provisioning Mode............. MANUAL
Contact.......................
Location......................
Name..........................
Services...................... Layer 2 - Datalink/Subnetwork
MGMT MAC address.............. Cannot Read MAC Address
Number of MACs on card........ 4
Description................... Telesyn 9700 Multiservice Access Platform
Hostname......................
MGMT IP Address............... 172.16.66.62
MGMT Subnet Mask.............. 255.255.255.0
MGMT Gateway.................. 172.16.66.1
MGMT Domainname...............
MGMT DNS......................
If any logs are produced, or if an alarm has a status other than INFO, contact ATI Technical Support and review
the output. See
1.24 .
1.21.1 Check software load
Check the software loads on the system cards using the SHOW CARD command. An example follows:
officer SEC>> SHOW CARD ACTCFC SOFTWARE
-------------------------------------------------------------------------------
Fault................................. No Faults
Card.................................. 8,9
Card Type............................. CFC24
Activity Status....................... ACTIVE
Admin State........................... UP
Operational State..................... UP
Status................................ Online
Profile Name.......................... AutoProv
Profile Has Been Modified............. No
Diagnostic Result..................... Not Run
Diagnostics Scheduled................. No
Temporary SW Load..................... None
Preferred SW Load..................... cfc24_4.0.0.BETA.20040708.tar
Alternate SW Load..................... None
Running Load.......................... cfc24_4.0.0.BETA.20040708.tar
Load File............................. vxWorks
Build Name............................ Telesyn 24G Central Fabric Controller
Build Type............................ Customer Build
Revision.............................. 4.0.0.BETA.20040715