Allied Telesis 9700 iMAP - Manual (Page 13)

Setup Checklist Selecting a Site (Office Installation)
1-7
ATI 9700 - Installation Guide (Initial Installation of the ATI 9700)
Crimping
Tool 1 Used to put ring terminals on power cabling.
#1 and #2
Phillips
screwdriver 1 Used for mounting the chassis
Ring Termi-
nals #6 studs for 6 AWG wire
RS232 cable 1 Used to connect local PC/terminal for local interface
Note: When using an AC-powered terminal or PC, use an
RS232 line isolation unit between the terminal/PC
and the RS232 port. For battery-powered devices,
such as a laptop, this is not required.
cable ties as needed n/a
Rack mount
adapters Recom-
mended for
19 in. or 23
in. rack
mounting Vendor: Newton Instrument Company
Part Number: 2086380945 (9RU Midnight Black adapters)
www.newtoninst.com
materials for
chassis
grounding as needed
for chassis
grounding 1. 6 AWG grounding cable (green with yellow stripe)
2. two nuts or a lock washer and a nut
3. double-crimp terminal (PANDUIT PMNF6-4R or equivalent)
MDF and
facilities inter-
face As required Blocks, cabling, connectors, etc. as required to connect CO facilities to ATI
equipment. MDF Upgrade Products for interfacing 8 / 16 / 24 port ADSL
modularity are available from ATI.
Small torque
wrench 1 Used to tighten bolts for chassis grounding stud.
TABLE 1-4 Customer Item Checklist (Continued)
Item Quantity Description