Allied Telesis 9700 iMAP User Manual
Page 44
Connecting the local terminal and applying power
Power and startup sequence
ATI 9700 - Installation Guide (Initial Installation of the ATI 9700)
1-38
officer SEC> SHOW ALARMS ALL
-------------------------------------------------------------------------------
Slot 10, Port 01 Loss Of Signal Major
Slot 10, Port 01 Loss Of Link Major
Slot 10, Port 01 Loss Of Sync Major
Slot 10, Port 02 Loss Of Signal Major
Slot 10, Port 02 Loss Of Link Major
Slot 10, Port 02 Loss Of Sync Major
-------------------------------------------------------------------------------
officer SEC> disable port 10.1,10.2
Service may be affected, are you sure (Y/N)? y
Info (039512): Operation Successful (GE3 Slot 10 Port 01)
Info (039512): Operation Successful (GE3 Slot 10 Port 02)
Once the alarms are cleared and there are no other alarms, go to step 10. If alarms are still present, go to step
6.
6.
Turn system power off
7.
Remove and replace the Control Module card for slot 8/9, following the guidelines in 1.10
8.
Start the power sequence again (return to Step 1 and repeat Steps 1 - 4)
9.
Since the Control Module in slot 8/9 has been replaced once and there are still faults, contact your ATI Tech-
nical Support. See
10.
Stop Installation Procedure
11.
Log into the system, input a user ID of officer and a password of officer
12.
Execute the PURGE DATABASE command. The system will erase the initial configuration database, reboot,
and recover with factory defaults. This provides a baseline for startup system configuration.
The system is initially in the auto-provisioning mode by default. This means that hardware is discovered in a slot
where there is no prior provisioning and the cards and ports are automatically provisioned. This discovery occurs
when:
•
The card is inserted into a slot
•
The card is already inserted and the following occurs:
1.
The Control Module powers up
2.
The Control Module reboots
3.
The system mode is changed from manual to autoprov.
13.
Determine the next step by whether the system will be in simplex or duplex configuration,
•
If simplex, go to section
•
If duplex, go to Step 14
14.
Install the second Control Module card in slot 12/13, following the procedure in section