Allied Telesis AlliedView-EMS 3.11 QoS MANAGER User Manual
Page 94
AlliedView™-EMS 3.11 QoS Manager User’s Guide
Page 94 of 146
Property
Name
Description
Valid Values
Class
class maxbandwidth setting.
•
YES
Ignore
Bandwidth
Class
Determines whether or not the
metering stage acknowledges any
previous bandwidth class assigned
to flows processed by the default
traffic class.
•
NO
•
YES
Mark Value
Specifies an explicit value to use
as an index into the DSCPMAP
table when the premarking
parameter is usemarkvalue.
•
0-63
•
none
Maximum
Bandwidth
Specifies the maximum bandwidth
available to the traffic class.
This can be set by entering a value using
one the following formats:
•
0-16000000 kbps
•
0-16000 Mbps (decimal point
supported)
•
0-16 Gbps (decimal point
supported)
•
none
Max Burst Size Specifies the burst tolerance for
the Maximum Bandwidth
parameter.
This can be set by entering a value using
one the following formats:
•
0-16777216 bytes
•
0~16384 KB (decimal point
supported)
•
0~16 MB (decimal point
supported)
•
0~0.015628 GB (decimal point
supported)
Note
- Byte measures can have the value
b,k,kb,m,mb,g,gb (case insensitive)
Minimum
Bandwidth
Specifies the minimum bandwidth
reserved for the traffic class.
This can be set by entering a value using
one the following formats:
•
0-16000000 kbps
•
0-16000 Mbps (decimal point
supported)
•
0-16 Gbps (decimal point
supported)
•
none
Min Burst Size Specifies the burst tolerance for This can be set by entering a value using