Allied Telesis AlliedView-EMS 3.11 QoS MANAGER - Manual (Page 102)

AlliedView™-EMS 3.11 QoS Manager User’s Guide Page 102 of 146
happens, any attempt to modify the classifier will result in the error message:
"Parameter VLANPRIORITY, value too high; maximum is 7."
• When the TAG Protocol ID classifier property is not set to any value and the VLAN
classifier property is set to 'any', the current firmware version automatically sets the
TAG Protocol ID to '8100'.
• Values entered for the Length scheduling property are rounded up to the nearest
multiple of 16.
• When the Maximum Bandwidth and Minimum Bandwidth traffic class properties are
set to any of the following values, the current firmware version automatically
converts these values to '16998400 kbps':
o
1600000kbps
o
16000mbps
o
16gbps
When this happens, any attempt to modify the traffic class will result in the error
message: "Invalid value."
• If the Premarking traffic class property is set to 'USEMARKVALUE' and the Mark
Value traffic class property is set to an integer value, they cannot be configured to
'none' at the same time. Premarking must be configured to 'none' first before Mark
Value can be configured to 'none'.
• If the Default Traffic Class Premarking policy property is set to 'USEMARKVALUE'
and the Mark Value policy property is set to an integer value, they cannot be
configured to 'none' at the same time. Default Traffic Class Premarking must be
configured to 'none' first before Mark Value can be configured to 'none'.
• The actual value of bytevalue that is configured for the EIPByte01-16 classifier
properties is computed by performing a bitwise AND operation between the
bytevalue and bytemask values supplied.
Ex.
bytevalue = 25 (00100101)
bytemask = 3B (00111011)
AND = 21 (00100001)
The hexadecimal value 21 will be the actual value configured.
• The current firmware version does not allow the Source MAC Address classifier
property to be set to 'dhcpsnooping'.
• The current firmware version does not allow Minimum and Maximum bandwidth
value of '0kbps', '0mbps' or '0gbps'. Attempting to assign these values will result in
the error message "Parameter MINBANDWIDTH, value too low; minimum is
1kbps." and "Parameter MAXBANDWIDTH, value too low; minimum is 1kbps.".