Allied Telesis AT-RPS3000 - Manual (Page 69)

AT-RPS3000 Redundant Power Supply Installation Guide
69
Powering On the Power Supply Modules
Perform this procedure to power on the power supply modules in the
AT-RPS3000 Chassis:
1. For the AT-PWR250 or AT-PWR800 Module, raise the power cord
retaining clip on the power supply module.
Figure 50. Raising the Power Cord Retaining Clip
2. Connect the AC power cord to the AC socket on the power supply
module, as shown in Figure 51 on page 70.
B
B
1
2
3
4
SYSTEM
PoE+ / SYSTEM
PoE+ / SYSTEM
SYSTEM
MODU LE B
MODU LE A
A
A
AT
-P W R 8 00
DC O UT FAULT
AT
-P W R 8 00
DC O UT FAULT
100-24 0 VAC~ 12A M AX
2164
100-24 0 VAC~ 12A M AX
DC O UT FAUL T
100-240 V AC~12A M
AX