Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 59)

Address Table Commands
Page 59
User Guidelines
There are no user guidelines for this command.
Example
The following example forwards all packets from port 1/g1 without learning addresses of packets from unknown
sources and sends traps every 100 seconds if a packet with an unknown source address is received.
port security mode
The port security mode Interface Configuration mode command configures the port security mode. Use the no
form of this command to return to the default configuration.
Syntax
port security mode {lock | max-addresses}
no port security mode
Parameters
•
lock — Saves the current dynamic MAC addresses associated with the port and disables learning, relearning
and aging.
• max-addresses — Delete the current dynamic MAC addresses associated with the port. Learn up to the
maximum addresses allowed on the port. Relearning and aging are enabled.
Default Configuration
Lock.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets port security mode to dynamic for Ethernet interface 1/g7.
port security max
The port security max Interface Configuration (Ethernet, port-channel) mode command configures the maximum
number of addresses that can be learned on the port while the port is in port security mode. Use the no form of
this command to return to the default configuration.
Syntax
port security max max-addr
console(config)# interface ethernet 1/g1
console(config-if)# port security forward trap 100
console(config)# interface ethernet 1/g7