Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 117)

Ethernet Configuration Commands
Page 117
The following table describes the fields shown in the display:
show system flowcontrol
The show system flowcontrol Privileged EXEC mode command displays the flow control state on cascade
ports.
Syntax
show system flowcontrol
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
Ch OutOctets OutUcastPkts OutMcastPkts OutBcastPkts
--- --------- ------------ ------------ ------------
1 23739 0 0 0
F i e l d D e s c r i p t i o n
InOctets Counted received octets.
InUcastPkts Counted received Unicast packets.
InMcastPkts Counted received Multicast packets.
InBcastPkts Counted received Broadcast packets.
OutOctets Counted transmitted octets.
OutUcastPkts Counted transmitted Unicast packets.
OutMcastPkts Counted transmitted Multicast packets.
OutBcastPkts Counted transmitted Broadcast packets.
FCS Errors Counted received frames that are an integral number of octets in length but do
not pass the FCS check.
Single Collision Frames Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
Late Collisions Number of times that a collision is detected later than one slotTime into the
transmission of a packet.
Oversize Packets Counted frames received that exceed the maximum permitted frame size.
Internal MAC Rx Errors Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Received Pause Frames Counted MAC Control frames received with an opcode indicating the PAUSE
operation.
Transmitted Pause Frames Counted MAC Control frames transmitted on this interface with an opcode
indicating the PAUSE operation.