Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 380)

Page 380
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
Parameters
•
seconds — Time in seconds that the device waits for a response from the authentication server.
(Range: 1 - 65535 seconds)
Default Configuration
The timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout server-timeout value and the result of
multiplying the radius-server retransmit value with the radius-server timeout value and selecting the lower of
the two values.
Example
The following example sets the time for the retransmission of packets to the authentication server to 3600
seconds.
show dot1x
The show dot1x Privileged EXEC mode command displays the 802.1X status of the device or specified interface.
Syntax
show dot1x [ethernet interface]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status of 802.1X-enabled Ethernet ports
console(config-if)# dot1x timeout server-timeout 3600
Console# show dot1x