Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 328)

Page 328
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
show sessions
The show sessions User EXEC mode command lists open Telnet sessions.
Syntax
show sessions
Parameters
This command has no arguments or keywords.
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example lists open Telnet sessions.
The following table describes significant fields shown above.
show system
The show system User EXEC mode command displays system information.
Syntax
show system [unit unit]
console> show sessions
Connection Host Address Port Byte
---------- ------------- ---------- ----- ----
1 Remote device 172.16.1.1 23 89
2 172.16.1.2 172.16.1.2 23 8
F i e l d D e s c r i p t i o n
Connection Connection number.
Host Remote host to which the device is connected through a Telnet session.
Address IP address of the remote host.
Port Telnet TCP port number
Byte Number of unread bytes for the user to see on the connection.