Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 107)

Ethernet Configuration Commands
Page 107
Parameters
•
on — Force flow control as enabled.
• off — Force flow control as disabled.
• auto — Enable AUTO flow control configuration.
Default Configuration
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Negotiation should be enabled for flow control auto.
Example
In the following example, flow control is enabled on port 1/g5.
mdix
The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a given interface. Use
the no form of this command to disable cable crossover.
Syntax
mdix {on | auto}
no mdix
Parameters
•
on — Manual mdix
• auto — Automatic mdi/mdix
Default Configuration
The default setting is on.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Auto: All possibilities to connect a PC with cross or normal cables are supported and are automatically detected.
On: It is possible to connect to a PC only with a normal cable and to connect to another device only with a cross
cable.
No: It is possible to connect to a PC only with a cross cable and to connect to another device only with a normal
cable.
console(config)# interface ethernet 1/g5
console(config-if)# flowcontrol on