Tunnel isatap solicitation-interval – Allied Telesis AT-S95 CLI (AT-8000GS Series) User Manual
Page 315
Tunnel Commands
Page 315
no tunnel isatap query-interval
Parameters
•
seconds — Specifies the number of seconds between DNS Queries. (Range: 10 - 3600)
Default Configuration
10 seconds.
Command Mode
Global Configuration mode.
User Guidelines
•
This command determines the interval of DNS queries before the IP address of the ISATAP router is known.
When the IP address is known, the robustness level that is set by the tunnel isatap robustness global
configuration command determines the refresh rate.
Example
The following example configures the interval between DNS Queries for the automatic tunnel router domain to 60
seconds.
tunnel isatap solicitation-interval
The tunnel isatap solicitation-interval Global Configuration mode command configures the interval between
ISATAP router solicitations messages (when there is no active ISATAP router). Use the no form of this command
to return to the default.
Syntax
tunnel isatap solicitation-interval seconds
no tunnel isatap solicitation-interval
Parameters
•
seconds — Specifies the number of seconds between ISATAP router solicitations messages. (Range: 10 -
3600)
Default Configuration
10 seconds.
Command Mode
Global Configuration mode.
User Guidelines
•
This command determines the interval of Router Solicitation messages when there is no active ISATAP
router. When there is an active ISATAP router, the robustness level that is set by the tunnel isatap robustness
global configuration command determines the refresh rate.
console(config)# tunnel isatap query-interval 60