Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 183)

LLDP Commands
Page 183
Example
The following example displays the Link Layer Discovery Protocol (LLDP) configuration:
The following table describes the significant fields shown in the example:
show lldp med configuration
The show lldp med configuration Privileged EXEC mode command displays the LLDP MED configuration.
Syntax
show lldp med configuration [ethernet interface]
console# show lldp configuration
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Port State Optional TLVs Address
---- ----- ------------- -------
1/g1 RX, TX PD, SN, SD, SC 172.16.1.1
1/g2 TX PD, SN 172.16.1.1
1/g2 Disabled
F i e l d D e s c r i p t i o n
Timer Specifies how often the software sends LLDP updates.
Hold multiplier Specifies the amount of time the receiving device should hold an LLDP packet
before discarding it.
Reinit timer Specifies the minimum time an LLDP port waits before reinitializing LLDP
transmission.
Tx delay Specifies the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB.
Port The port number.
State The port LLDP state.
Optional TLVs Optinal TLVs that are advertised. Possible values are:
• PD – Port description
• SN – System name
• SD – System description
• SC – System capabilities
Address The management address that is advertised.