Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 225)

Radius Commands
Page 225
Example
The following example configures the source IP address used for communication with RADIUS servers to
10.1.1.1.
radius-server source-ipv6
The radius-server source-ipv6 Global Configuration mode command specifies the source IP address used for
IPv6 communication with the RADIUS servers. Use the no form of this command to return to the default
configuration.
Syntax
radius-server source-ipv6 source
no radius-server source-ipv6 source
Parameters
•
source — Specifies a valid source IPv6 address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies the source IP address used for IPv6 communication with the RADIUS servers.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval during which the device waits
for a server host to reply. Use the no form of this command to return to the default configuration.
Syntax
radius-server timeout timeout
no radius-server timeout
Parameters
•
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
console(config)# radius-server source-ip 10.1.1.1
console(config)# radius-server source-ipv6 3156::98