Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 185)

LLDP Commands
Page 185
show lldp local
The show lldp local Privileged EXEC mode command displays the LLDP information advertised from a specific
port.
Syntax
show lldp local ethernet interface
Parameters
•
interface — Ethernet interface.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the Link Layer Discovery Protocol (LLDP) information that is advertised from the
Ethernet interface.
console# show lldp local ethernet 1/g1
Device ID: 0060.704C.73FF
Port ID: 1
Capabilities: Bridge
System Name: ts-7800-1
System description:
Port description:
Management address: 172.16.1.8
802.3 MAC/PHY Configuration/Status
Auto-negotiation support: Supported
Auto-negotiation status: Enabled
Auto-negotiation Advertised Capabilities: 100BASE-TX full duplex, 1000BASE-T full duplex
Operational MAU type: 1000BaseTFD
LLDP-MED capabilities: Network Policy, Location Identification
LLDP-MED Device type: Network Connectivity
LLDP-MED Network policy
Application type: Voice
Flags: Tagged VLAN
VLAN ID: 2
Layer 2 priority: 0
DSCP: 0
LLDP-MED Power over Ethernet