Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 22)

Page 22
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
command is entered. If the characters already entered are not enough for the system to identify a single matching
command, press ? to display the available commands matching the characters already entered.
Nomenclature
When referring to an Ethernet port in a CLI command, the following format is used:
• For an Ethernet port on a standalone device: Ethernet_type port_number
• For an Ethernet port on a stacked device: unit_number/Ethernet_type port number
The Ethernet type is Gigabit Ethernet (indicated by “g”).
For example, g3 stands for Gigabit Ethernet port 3 on a stand-alone device, whereas 1/g3 stands for Gigabit
Ethernet port 3 on stacking unit 1.
The ports may be described on an individual basis or within a range. Use the format port number-port number to
specify a set of consecutive ports and port number, port number to indicate a set of non-consecutive ports. For
example, g1-3 stands for Gigabit Ethernet ports 1, 2, and 3 and g1, 5 stands for Gigabit Ethernet ports 1 and 5.
Keyboard Shortcuts
The CLI has a range of keyboard shortcuts to assist in editing the CLI commands. The following table describes
the CLI shortcuts.
CLI Command Conventions
When entering commands there are certain command entry standards that apply to all commands. The following
table describes the command conventions.
K e y b o a r d K e y D e s c r i p t i o n
Up-arrow key Recalls commands from the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
Down-arrow key Returns the most recent commands from the history buffer after recalling commands with
the up arrow key. Repeating the key sequence will recall successively more recent
commands.
Ctrl+A Moves the cursor to the beginning of the command line.
Ctrl+E Moves the cursor to the end of the command line.
Ctrl+Z / End Returns back to the Privileged EXEC mode from any configuration mode.
Backspace key Deletes one character left to the cursor position.
C o n v e n t i o n D e s c r i p t i o n
[ ] In a command line, square brackets indicates an optional entry.
{ } In a command line, curly brackets indicate a selection of compulsory parameters
separated by the | character. One option must be selected. For example: flowcontrol
{auto|on|off} means that for the flowcontrol command either auto, on or off must be
selected.
Italic font Indicates a parameter.
Indicates an individual key on the keyboard. For example, indicates the Enter
key.