Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 113)

Ethernet Configuration Commands
Page 113
show interfaces status
The show interfaces status Privileged EXEC mode command displays the status of all configured interfaces.
Syntax
show interfaces status [ethernet interface| port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status of all configured interfaces:
g9 100M-Copper Full 100 Enabled Off Up Disabled Auto
g10 100M-Copper Full 100 Enabled Off Up Disabled Auto
g11 100M-Copper Full 100 Enabled Off Up Disabled Auto
g12 100M-Copper Full 100 Enabled Off Up Disabled Auto
g13 100M-Copper Full 100 Enabled Off Up Disabled Auto
g14 100M-Copper Full 100 Enabled Off Up Disabled Auto
g15 100M-Copper Full 100 Enabled Off Up Disabled Auto
g16 100M-Copper Full 100 Enabled Off Up Disabled Auto
g17 100M-Copper Full 100 Enabled Off Up Disabled Auto
g18 100M-Copper Full 100 Enabled Off Up Disabled Auto
g19 100M-Copper Full 100 Enabled Off Up Disabled Auto
console# show interfaces status
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
Back
Pressure
Mdix
Mode
---- ----------- ------ ----- ------- ---- ----- -------- ----
g1 100M-Copper -- -- -- -- Down -- --
g2 100M-Copper -- -- -- -- Down -- --