Allied Telesis AT-GS950/48 - Manual (Page 61)

AT-GS950/48 Web Interface User Guide
61
3. From the Syslog Status field, select one of the following choices from
the pull-down menu:
Enabled - The System log is active.
Disabled - The System log is inactive.
4. From the Time Stamp field, select one of the following choices from the
pull-down menu:
Enabled - Each event message recorded in the log will have a time
stamp recorded with it.
Disabled - No time stamp will be recorded with the event
messages.
5. Enter the Messages Buffer Size.The range is between 1 and 200.
6. Enter the Syslog Server IP Address:
IPv4 addresses: Click IPv4, then enter the address.The format is
xxx.xxx.xxx.xxx. If the address is left at the default setting of
0.0.0.0, no server is specified.
IPv6 addresses: Click IPv6, then enter the address.The format is
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxx in hexadecimal digits.
7. In the Facility field, enter the Facility local from the pull-down menu.
The choices range from local0 through local7.
8. Select the Logging Level. This parameter specifies which level of
event messages will be logged into the System log. Your choices are
as follows:
Alert - Action must be taken immediately.
Critical - Critical conditions are displayed.
Warning - Warning conditions are displayed.
Info - Informational messages are displayed
9. Click Apply.
The System log is now active.
10. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.