Allied Telesis AT-GS950/48 - Manual (Page 216)

Chapter 16: SNMPv1 and v2c
216
Note
If you choose to use the default User and Group Names (ReadOnly
and ReadWrite) that are already displayed in the table, proceed to
Step 7 below.
3. Type a new User Name.
Enter a name up to 32 characters in length.
4. Type a previously defined Group Name.
Enter a name up to 32 characters in length.
5. Select either v1 or v2c as the SNMP Version.
Note
The encrypted check-box and Auth-Protocol, Priv-Protocol, and
password fields are intended for SNMPv3 configurations only and
are not used for SNMPv1 or v2c configurations.
6. Click Add.
See Figure 78 for an example of the SNMP User/Group page.
Figure 78. SNMP User/Group Page Example
7. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.