Allied Telesis AT-GS950/48 - Manual (Page 36)

Chapter 2: System Configuration
36
IPv6 Neighbor Configuration
You can configure the switch’s IPv6 neighbors manually if a router is
unavailable.
The procedures in this section describe how to add IPv6 neighbors or
remove them from the list and how to find IPv6 neighbors in the list.
See the following sections:
 "Create an IPv6 Neighbor List"
 “Delete an IPv6 Neighbor Entry” on page 37
 “Find an IPv6 Neighbor” on page 37
Create an IPv6
Neighbor List
To create a list of IPv6 neighbors, perform the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select IPv6 Neighbor Settings.
The IPv6 Neighbor Settings Page is displayed. See Figure 8.
Figure 8. IPv6 Neighbor Settings Page
3. Enter an IPv6 address in the Neighbor IPv6 Address field using
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format, where each x is a
hexadecimal digit representing 4 bits.
4. Enter a link layer MAC address in the Link Layer MAC Address field.
5. Click Add.
The IPv6 address and link layer MAC address are added to the list.
See Figure 9 on page 37.