Allied Telesis AT-GS950/48 - Manual (Page 345)

AT-GS950/48 Web Interface User Guide
345
Download or Upload a Configuration File via HTTP
This section describes how to download or upload a configuration file
using HTTP on an Internet server. For example, you can save the switch’s
configuration file to your PC, then the saved file can be transferred to other
switches.
Before you download or upload a configuration file via HTTP, note the
following:
 You must be able to access the new AT-S116
configuration file from your PC when uploading a file
from a PC to the switch.
 The switch that you are working with must have an IP
address and subnet mask assigned, either manually or
via DHCP. For instructions on how to manually set the
IP address and subnet mask on a switch, see
“Configuration of IPv4 Address, Subnet Mask and
Gateway Address” on page 32. To enable a DHCP
client, see “DHCP Client Configuration” on page 53.
To download an AT-S116 configuration file to your PC or upload an AT-
S116 configuration file onto the switch using a web browser, perform the
following procedure:
1. From the menu on the left side of the home page, select the Tools
folder.
The Tools folder expands.
2. From the Tools folder, select Config File Backup/Restore folder.
The Config File Backup/Restore folder expands.
3. From the Config File Backup/Restore folder, select via HTTP.
The Configuration File Backup/Restore via HTTP page is displayed.
See Figure 136.
Figure 136. Configuration File Backup/Restore via HTTP Page