Wesley BC-620-4CA - Manual (Page 68)

64 Curtis 1234/36/38 Manual,
OS
11
4
a
4a — MONITOR MENU
MONITOR MENU
Through its Monitor menu, the 1311 programmer
provides access to real-time data during vehicle
operation. This information is helpful during
diagnostics and troubleshooting, and also while
adjusting programmable parameters.
MONITOR MENU
—Inputs ................. p. 64
—Outputs .............. p. 67
—Battery ............... p. 68
—Motor ................. p. 68
—Controller ........... p. 69
–Cutbacks ........ p. 70
–Motor Tuning .. p. 70
—Vehicle ............... p. 71
—CAN Status ........ p. 73
Monitor Menu: INPUTS
DISPLAY
VARIABLE RANGE DESCRIPTION
Throttle Command -100–100 % Throttle request to slew rate block.
Throttle_Command -32768–32767
Mapped Throttle -100–100 % Mapped throttle request.
Mapped_Throttle -32768–32767
Throttle Pot 0–5.5 V Voltage at throttle pot wiper (pin 16).
Throttle_Pot_Raw 0–36044
Brake Command 0–100 % Brake request to slew rate block.
Brake_Command 0–32767
Mapped Brake 0–100 % Mapped brake request.
Mapped_Brake 0–32767
Pot2 Raw 0–5.5 V Voltage at pot2 wiper (pin 17).
Pot2_Raw 0–36044
PD Throttle 0–100 % Proportional driver current request.
PD_Throttle 0–32767
Steer Pot 0–5.5 V Voltage at steer pot wiper (pin 17) on Dual
Steer_Pot_Raw 0–36044 Drive traction slave.
Steer Angle -90 – 90 deg Steer angle calculated in Dual Drive .
Steer_Angle -90 – 90 traction master.
Interlock On/Off Interlock input on or off. The source of the
Interlock_State On/Off interlock input is determined by the Interlock
System_Flags1 [Bit 0] Type parameter:
from Switch 3 (pin 9) if Interlock Type = 0
from VCL function if Interlock Type = 1
from KSI (pin 1) if Interlock Type = 2.