Campbell Scientific HydroSense II Support Software User Guide - Manual (Page 32)

Section 4. Viewing Data
The following columns are in the data list:
TABLE 4-1. Data List
Element Description
TimeStamp HydroSense time when the measurement was made
Record
Number Record numbers range from 1 to 65535
Zone Zone where this measurement is located
Latitude Latitude (°N of the equator) where this measurement was
made
Longitude Longitude (°E of the prime meridian) where this measurement
was made
Moisture ( % ) Volumetric water content (VWC) reported in percent (%).
Only water content is plotted on the Chart tab. Additional
raw measurements with units are shown in the Data tab
3. Timeline
The timeline allows the user to filter the points in the data list based on when
the measurements were taken. By default, the Select All Dates checkbox is
selected and all measurements are displayed. For information using the
timeline, see
SECTION 4.1 Using the Timeline (p. 4-1).
4.3.2 Point Options
4.3.2.1 Find In Map View
To locate a given point in the Map View, right click on the desired row
(multiple rows can also be selected) in the Data View and choose Find In Map
View. Alternatively, double clicking on the row will perform the same
function.
4-6